What's New in Design Assistant 5.2

     
	   Version 5.25	July, 2008

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
	5.25 Maintenance notes:

> Macro command line switches properly load the
  correct macro file.

> Backfeed Replacement is properly detecting aerial
  and underground cable types.

> Autofont no longer causes a problem when restarting
  the Design Assistant

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
	5.24 Maintenance notes:

> Issues with key checking and Pricing specs have been
  resolved.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
	5.23 Maintenance notes:

> Inserting a PCD no longer causes an effect on the
  signal levels.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
	5.22 Maintenance notes:

> Editing Loss/Out in Active Specs and saving no 
  longer causes some fields to revert values.

> Creating a new Actives file will properly display
  full spectrum equalizer values.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
	5.21 Maintenance notes:

> There is no longer a problem displaying values in
  the EQ banks of the Actives Specs.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
	5.20 New Features/Enhancements:

> In the Actives Specs you can now set frequencies to
  be a loss rather than an output. If the frequencies
  are set to be a loss they will not be considered
  for pads and equalizers. This new feature was
  introduced to handle the retro fit of amplifiers
  that only amplify certain frequencies and allow
  other frequencies to pass through with some loss.

> Macro support for Excel active reports has been
  added.

> Excel control file BOM's have been reformatted by
  changing the location of the network names. This
  change was made so the active information will
  always begin on the same line.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

	5.20 Maintenance notes:

> All frequency headings in the MDU window are now
  properly displayed.

> Jump to amp label, footage pair and power supply
  are functioning properly.

> Key drivers are installing properly for Windows
  Vista.

> The Test Network function will now always place the
  cursor in the test window at the error you were at
  when the test was performed and the errors are
  listing in the Branch/Node order as they are in the
  network.

> When making a change to any field in any spec file
  and saving, the values are always retained.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~